Home > Research > Publications & Outputs > Distal deposition of tephra from the Eyjafjalla...

Associated organisational unit

Electronic data

  • 2011JB008904

    Rights statement: ©2012. American Geophysical Union. All Rights Reserved.

    Final published version, 1.29 MB, PDF document

    Available under license: CC BY-NC: Creative Commons Attribution-NonCommercial 4.0 International License

Links

Text available via DOI:

View graph of relations

Distal deposition of tephra from the Eyjafjallajokull 2010 summit eruption

Research output: Contribution to Journal/MagazineJournal articlepeer-review

Published
  • J. A. Stevenson
  • S. Loughlin
  • C. Rae
  • T. Thordarson
  • A. E. Milodowski
  • J. S. Gilbert
  • S. Harangi
  • R. Lukacs
  • B. Hojgaard
  • U. Arting
  • S. Pyne-O'Donnell
  • A. MacLeod
  • B. Whitney
  • M. Cassidy
Close
Article numberB00C10
<mark>Journal publication date</mark>09/2012
<mark>Journal</mark>Journal of Geophysical Research: Solid Earth
Issue numberB9
Volume117
Number of pages10
Publication StatusPublished
Early online date6/06/12
<mark>Original language</mark>English

Abstract

The 2010 Eyjafjallajokull lasted 39 days and had 4 different phases, of which the first and third (14-18 April and 5-6 May) were most intense. Most of this period was dominated by winds with a northerly component that carried tephra toward Europe, where it was deposited in a number of locations and was sampled by rain gauges or buckets, surface swabs, sticky-tape samples and air filtering. In the UK, tephra was collected from each of the Phases 1-3 with a combined range of latitudes spanning the length of the country. The modal grain size of tephra in the rain gauge samples was 25 mu m, but the largest grains were 100 mu m in diameter and highly vesicular. The mass loading was equivalent to 8-218 shards cm(-2), which is comparable to tephra layers from much larger past eruptions. Falling tephra was collected on sticky tape in the English Midlands on 19, 20 and 21st April (Phase 2), and was dominated by aggregate clasts (mean diameter 85 mu m, component grains <10 mu m). SEM-EDS spectra for aggregate grains contained an extra peak for sulphur, when compared to control samples from the volcano, indicating that they were cemented by sulphur-rich minerals e. g. gypsum (CaSO4 center dot H2O). Air quality monitoring stations did not record fluctuations in hourly PM10 concentrations outside the normal range of variability during the eruption, but there was a small increase in 24-hour running mean concentration from 21-24 April (Phase 2). Deposition of tephra from Phase 2 in the UK indicates that transport of tephra from Iceland is possible even for small eruption plumes given suitable wind conditions. The presence of relatively coarse grains adds uncertainty to concentration estimates from air quality sensors, which are most sensitive to grain sizes <10 mu m. Elsewhere, tephra was collected from roofs and vehicles in the Faroe Islands (mean grain size 40 mu m, but 100 mu m common), from rainwater in Bergen in Norway (23-91 mu m) and in air filters in Budapest, Hungary (2-6 mu m). A map is presented summarizing these and other recently published examples of distal tephra deposition from the Eyjafjallajokull eruption. It demonstrates that most tephra deposited on mainland Europe was produced in the highly explosive Phase 1 and was carried there in 2-3 days.

Bibliographic note

©2012. American Geophysical Union. All Rights Reserved.