Final published version
Research output: Contribution to Journal/Magazine › Journal article › peer-review
<mark>Journal publication date</mark> | 07/2008 |
---|---|
<mark>Journal</mark> | Preparative Biochemistry and Biotechnology |
Issue number | 3 |
Volume | 38 |
Number of pages | 11 |
Pages (from-to) | 246-256 |
Publication Status | Published |
Early online date | 24/06/08 |
<mark>Original language</mark> | English |
The production of carotenoids from Blakeslea trispora cells in a synthetic medium has been reported, with the main products being β-carotene, lycopene, and γ-carotene. The effect of biomass pretreatment and solvent extraction on their selective recovery is reported here. Eight solvents of class II and III of the International Conference of Harmonization: ethanol, methanol, acetone, 2-propanol, pentane, hexane, ethyl acetate, and ethyl ether, and HPLC analysis were used for the evaluation of their selectivities towards the three main carotenoids with regard to different biomass pre-treatment. The average Cmax values (maximum concentration of caronoids in a specific solvent) were estimated to 16 mg/L with the five out of eight solvents investigated, whereas methanol, pentane, and hexane gave lower values of 10, 11, and 9 mg/L, respectively. The highest carotenoid yield was obtained in the case of wet biomass, where 44-56% is recovered with one solvent and three extractions and the rest is recovered only after subsequent treatment with acetone; thus, four extractions of 2.5 h are needed. Two extractions of 54 min are enough to recover carotenoids from dehydrated biomass, with the disadvantage of a high degree of degradation. Our results showed that, for maximum carotenoid recovery, ethyl ether, 2-propanol, and ethanol could be successfully used with biomass without prior treatment, whereas fractions enriched in β-carotene or lycopene can be obtained by extraction with the proper solvent, thus avoiding degradation due to time-consuming processes.