12,000

We have over 12,000 students, from over 100 countries, within one of the safest campuses in the UK

93%

93% of Lancaster students go into work or further study within six months of graduating

Home > Research > Publications & Outputs > Sensitivity analysis of EUROSEM using Monte Car...
View graph of relations

« Back

Sensitivity analysis of EUROSEM using Monte Carlo simulation II: the effect of rills and rock fragments

Research output: Contribution to journalJournal article

Published

Journal publication date15/04/2000
JournalHydrological Processes
Journal number5
Volume14
Number of pages13
Pages927-939
Original languageEnglish

Abstract

A sensitivity analysis of the surface and catchment characteristics in the European soil erosion model (EUROSEM) was carried out with special emphasis on rills and rock fragment cover. The analysis focused on the use of Monte Carlo simulation but was supplemented by a simple sensitivity analysis where input variables were increased and decreased by 10%. The study showed that rock fragments have a significant effect upon the static output parameters of total runoff, peak flow rate, total soil loss and peak sediment discharge, but with a high coefficient of variation. The same applied to the average hydrographs and sedigraphs although the peak of the graphs was associated with a low coefficient of variation. On average, however, the model was able to simulate the effect of rock fragment cover quite well. The sensitivity analysis through the Monte Carlo simulation showed that the model is particularly sensitive to changes in parameters describing rills and the length of the plane when no rock fragments are simulated but that the model also is sensitive to changes in the fraction of non-erodible material and interrill slope when rock fragments were embedded in the topsoil. For rock fragments resting on the surface, changes in parameter values did not affect model output significantly. The simple sensitivity analysis supported the findings from the Monte Carlo simulation and illustrates the importance when choosing input parameters to describe both rills and rock fragment cover when modelling with EUROSEM.