Home > Research > Publications & Outputs > Influence of the microstructure on mechanical p...

Electronic data

  • Final

    Rights statement: This is the author’s version of a work that was accepted for publication in Journal of Alloys and Compounds. Changes resulting from the publishing process, such as peer review, editing, corrections, structural formatting, and other quality control mechanisms may not be reflected in this document. Changes may have been made to this work since it was submitted for publication. A definitive version was subsequently published in Journal of Alloys and Compounds, 894, 2021 DOI: 10.1016/j.jallcom.2021.162525

    Accepted author manuscript, 3.23 MB, PDF document

    Available under license: CC BY-NC-ND

Links

Text available via DOI:

View graph of relations

Influence of the microstructure on mechanical properties of SLM additive manufacturing Fe-based bulk metallic glasses

Research output: Contribution to Journal/MagazineJournal articlepeer-review

Published
  • Q. Jiang
  • P. Zhang
  • J. Tan
  • Z. Yu
  • Y. Tian
  • S. Ma
  • D. Wu
Close
Article number162525
<mark>Journal publication date</mark>15/02/2022
<mark>Journal</mark>Journal of Alloys and Compounds
Volume894
Number of pages13
Publication StatusPublished
Early online date29/10/21
<mark>Original language</mark>English

Abstract

Fe-based bulk metallic glass (BMG)(FeCrMoWMnSiBC) was produced by selective laser melting (SLM) successfully in this study. The best parameters were determined through extensive experiments. The relative density (95%) and amorphous rate (95.47%) samples were obtained by this parameter. The analysis of the microstructure reveals that the crystalline phases in the heat affected zone (HAZ) are mainly α-Fe and M23(CB)6 phases, and co-exist with the amorphous phases. The Heat treatment is employed to study the crystallization behavior of amorphous phases. The α-Fe phase, as the primary phase, grows into a submicron crystal phase under the action of multiple thermal cycles. Nanoindentation test results show that the hardness of the amorphous phase is higher than that of the nano-grain region, and the hardness of the nanocrystalline region is higher than that of the submicron-grain region. The free volume content is different and the amorphous phase is not uniform due to the complex thermal cycle. The maximum hardness occurs in the amorphous phase with 22.6 GPa.

Bibliographic note

This is the author’s version of a work that was accepted for publication in Journal of Alloys and Compounds. Changes resulting from the publishing process, such as peer review, editing, corrections, structural formatting, and other quality control mechanisms may not be reflected in this document. Changes may have been made to this work since it was submitted for publication. A definitive version was subsequently published in Journal of Alloys and Compounds, 894, 2021 DOI: 10.1016/j.jallcom.2021.162525