A smart repeater is proposed for driving capacitively-coupled, global-length on-chip interconnects that alters its drive strength dynamically to match the relative bit pattern on the wires and thus the effective capacitive load. This is achieved by partitioning the driver into main and assistant drivers; for a higher effective load capacitance both drivers switch, while for a lower effective capacitance the assistant driver is quiet. In a UMC 0.18-mum technology the potential energy saving is around 10% and the reduction in jitter 20%, in comparison to a traditional repeater for typical global wire lengths. It is also shown that the average energy saving for nanometer technologies is in the range of 20% to 25%. The driver architecture exploits the fact that as feature sizes decrease, the capacitive load per transistor shrinks, whereas global wire loads remain relatively unchanged. Hence, the smaller the technology, the greater the potential saving.
"©2008 IEEE. Personal use of this material is permitted. However, permission to reprint/republish this material for advertising or promotional purposes or for creating new collective works for resale or redistribution to servers or lists, or to reuse any copyrighted component of this work in other works must be obtained from the IEEE." "This material is presented to ensure timely dissemination of scholarly and technical work. Copyright and all rights therein are retained by authors or by other copyright holders. All persons copying this information are expected to adhere to the terms and constraints invoked by each author's copyright. In most cases, these works may not be reposted without the explicit permission of the copyright holder."
